With the newly released version 3.0.5, you can set different infill parameters by layer or by setting group. If there is any defect or damage caused by the use of third-party. For recommended settings in Simplif圓D, please check the attached. I ended up restarting the printer because it wouldn't stop when I pressed 'stop' on the front screen and the time showed no signs of stopping and either. The recommended print speed is less than 60 mm/s, the recommended travel speed is less than 80 mm/s, and the recommended initial layer speed is less than 24 mm/s. Also, the estimated time just kept going up and up. I loaded it onto a memory stick, put it in the printer, selected print and it seemed to be starting as I'd expect, but I noticed the right extruder was heating when it should have been the left. I just created some Gcode in S3D as I used to, using pretty much standard settings. I like some of the S3D features, such as the ability to print with different infill settings, so want to be able to use it with the N2. I bought S3D while using my previous machine but now have an N2. DeftCAD wrote:Just did a search and found this thread so thought I'm reviving it rather than starting another.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |